| A Simplified Four Step Process |
|
|
Step 1
A Golftek face tape decal is applied to the face of the club to be
measured. Position lower edge of the decal exactly in line with the
bottom clubface groove or the lower edge of the clubface. |
|
|
Step 2
The test ball is placed on a hitting mat or tee so that the groove is
perpendicular, or at a right angle to the hitting surface and aligned
with the target line. If necessary, the slotted plastic alignment aid
can be used to help properly orient the ball. Point the arrow at your
target; then, looking directly down on the ball, align the groove with
the target line. Remove the alignment aid before hitting the ball. |
|
|
Step 3
The grooved test ball leaves a distinctive vertical imprint line on the
face tape during impact.
|
|
|
Step 4
The amount of lie angle adjustment needed is easy to measure. Draw a
line through the center of the lie angle mark on the tape so that it
intersects both the upper and lower line of 2 degree angle marks. Count
the number of marks between the two points of intersection to determine
the exact angle. |
